Handgrip and knob
Home > Products > D - CONTROL HANDWHEELS > -
D211 TWO SPOKE CONTROL HANDWHEEL WHITH REVOLVING HANDLE M202

D211 TWO SPOKE CONTROL HANDWHEEL WHITH REVOLVING HANDLE M202


TECHNICAL DATA
D211 - 2 SPOKE CONTROL HANDWHEEL WITH REVOLVING HANDLE M202

MATERIAL:
Reinforced and stabilised polyamide.
Oils and greases resistant.

SURFACE: SATIN.

COLOUR: BLACK (RAL 9011).

CENTRAL CAP:
Grey polyamide (RAL 7035 cod. 13).

ALTERNATIVE CAP COLOUR:
Orange (RAL 2004 cod. 02)
Blue (RAL 5015 cod. 07)
Yellow (RAL 1021 cod. 10)
Red (RAL 3000 cod. 16)
Green (RAL 6024 cod. 17)
Black (RAL 9011 cod. 01)

MAIN INSERT:
Zinc plated steel insert with smooth through-hole (H10 tolerance).

SIDE INSERT:
Brass right through threaded bush.

SIDE HANDLE:
Revolving and folding handle art. M202 (pag M-18).

HUB:
Solid hub.
(*) Hollow underneath hub.
For fixing system, or execution of keyway or square holes, please refer to the technical notes attached to the catalogue.

SPECIAL REQUEST:
• It’s possible to supply the inserts with d1 bore by customer design, on request and for quantities.
• It’s possible to supply the inserts in different material and treatment-finishes, on request and for quantities.
• It’s possible to supply the products with colours ( reduced range) as shown in the table at page D-19, on request and for quantities.
Version with zinc plated insert and H10 tolerance bore

ATTENTION: BORE D1 (H10 TOLERANCE) COULD BE PRODUCED BY REQUEST, WITH 50 PIECES MINIMUM.
Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).
Version with black-oxide insert and H7 tolerance bore

ATTENTION: REPLACE THE TWO PLACES IN THE CODE .. WITH THE HOLE DIAMETER REQUIRED - 50 PIECES MINIMUM.
Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).
A.R. = By request